Used Kenworth Conventional Day Cab Trucks For Sale
Compare used Kenworth conventional day cab trucks for sale by T680, T880, and T800 specs, drivetrain history, axle ratings, and emissions requirements.
Showing 85 to 86 of 86 results
Selling a used kenworth conventional day cab truck? List your used kenworth conventional day cab truck for sale and reach thousands of commercial buyers.
Used Kenworth Conventional Day Cab Trucks
T680 aerodynamics suit highway-heavy routes, while T880 and T800 vocational configurations deserve close attention to frame ratings, suspension, and PTO equipment. Later Kenworth day cabs commonly use PACCAR MX-13 or Cummins X15 power, with manual or automated manual transmissions. Older examples may use Cummins ISX or Caterpillar engines, so verify the engine serial number and service records. Match axle ratio, transmission gearing, tire size, and torque to loaded starts and cruise speed rather than horsepower alone. Check fifth-wheel travel, trailer swing clearance, axle loading, and wet-kit compatibility for tank, dump, or lowboy work. Shorter wheelbases improve maneuverability but can restrict trailer clearance and weight distribution.
Obtain ECM mileage, engine hours, idle time, fault history, and repair invoices before evaluating a used Kenworth’s condition. Inspect frame rails, crossmembers, cab mounts, steering joints, and fifth-wheel wear, then road-test under load. Most 2007-era and newer highway diesels have DPF systems; many 2010-era and newer engines add SCR and DEF. Verify emissions eligibility for intended routes, especially California. Salt exposure in the U.S. Snow Belt and Canada calls for close inspection behind frame brackets and suspension mounts, while state and provincial axle limits must be checked against the actual loaded combination.
Frequently Asked Questions about Used Kenworth Conventional Day Cab Trucks
Does a PTO-equipped Kenworth day cab already have everything needed to pull a dump trailer?
No. An installed PTO does not establish that a used Kenworth day cab has a complete, compatible wet kit. Verify pump flow, operating pressure, reservoir capacity, hydraulic connections, and cab controls against the trailer manufacturer’s requirements. An end-dump hydraulic system is not automatically suitable for a walking-floor trailer, which can require different plumbing, continuous flow, and additional cooling.
What should I check on a used Kenworth day cab with an automated manual transmission?
A used Kenworth automated manual should engage forward and reverse cleanly, launch without excessive shudder, and shift consistently under load. Test low-speed backing and loaded hill starts, not just highway operation. Request transmission fault records, clutch wear data where supported, and documentation of clutch replacement or calibration. Confirm the exact transmission model because service requirements differ between Eaton and PACCAR systems.
Does remaining factory warranty transfer when I buy a used Kenworth day cab?
Remaining warranty transfers only when the specific coverage terms permit it and any required transfer steps are completed. Verify a used Kenworth day cab’s coverage directly by VIN and engine serial number, including expiration dates, mileage limits, covered components, and deductibles. Engine, aftertreatment, transmission, and chassis coverage can have different terms, so a general warranty statement is not enough.
Is a Kenworth converted from a sleeper acceptable for day cab work?
Yes, a properly completed sleeper conversion can serve day cab work, but the conversion needs a separate structural and installation inspection. Check the rear cab closure, weather sealing, cab mounts, wiring, HVAC changes, and seat clearance. A converted Kenworth may retain a longer wheelbase than a factory day cab, affecting turning space, tractor weight, and axle loading.
Does a 40,000-pound rear tandem let a Kenworth tractor carry 40,000 pounds on those axles?
No. A 40,000-pound tandem rating describes component capacity, not automatic legal axle loading. On U.S. Interstate highways, the standard tandem axle limit is generally 34,000 pounds, subject to applicable exceptions and permits. A Kenworth day cab’s legal combination weight also depends on axle spacing, bridge limits, tire ratings, and route restrictions. Canadian provincial limits must be checked separately.
